Siemens SIWAREX WL230 BB-S SA 사용 설명서 - 페이지 21

{카테고리_이름} Siemens SIWAREX WL230 BB-S SA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIWAREX WL230 BB-S SA 44 페이지. Base plate and elastomer bearing bb-s sa
Siemens SIWAREX WL230 BB-S SA에 대해서도 마찬가지입니다: 매뉴얼 (36 페이지), 사용 설명서 (48 페이지), 장비 매뉴얼 (50 페이지)

페이지 인쇄

4.2

Installing the base plate and elastomer bearing

4.2.1

General installation information

The installation conditions vary widely. The dead load of the load bearing implement can be

very low or relatively high. You might be dealing with a container, platform or a roller table. The

following installation instructions therefore only describe the general procedures.

To protect the load cells from damage during installation, always set up the load bearing

implement on dummies.

To place the elastomer bearings, lift the load carrier from bracket to bracket by only a few

millimeters. This section describes the assembly for this situation.

Note

Maintenance-friendly design

● When planning the layout, ensure that the load cells are easily accessible once they are

installed.

Depending on the installation conditions, the detailed procedure deviates from the following

description.

4.2.2

Overview

The following actions are required to install the elastomer bearing.

1. Preparing the load cell (Page 22)

2. Preparing the base plate and elastomer bearing (Page 22)

3. Mounting the elastomer bearing unit (Page 22)

4. Install the load cell with elastomer bearing unit (Page 23)

5. Set overload protection (Page 25)

6. Compensation of height with four or more support points (Page 25)

7. Checking the installation (Page 26)

8. Installing the grounding cable (Page 26)

The actions are described in detail in the following.

BB-S SA

Operating Instructions, 03/2020, A5E47358100-AA

4.2 Installing the base plate and elastomer bearing

Installation