Siemens SITRANS RD500 사용 설명서 - 페이지 39
{카테고리_이름} Siemens SITRANS RD500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SITRANS RD500 48 페이지. Configuring sitrans rd500 for connection to multiranger with modbus rtu
Siemens SITRANS RD500에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 사용 설명서 (8 페이지), 사용 설명서 (8 페이지), 애플리케이션 매뉴얼 (6 페이지), 매뉴얼 (11 페이지), 적용 사례 (9 페이지)
페이지 인쇄
Appendix A: Input Modules
Modbus Port
Belden 9842 is a multi-conductor cable which is recommended for use with
Note:
RS-485 industrial networks. The cable comprises four conductors and an overall
braided shield. It is recommended that you use three of the four conductors for A,
B, and Common connections. The shield on the cable should be connected to
ground at one point to ensure best noise immunity.
The RD500 hardware includes an RS-485 Modbus RTU interface to field instruments
using an RJ-45 connector.
•
Allows for long cable runs and multi-drop instrument connection.
•
Address up to 247 Modbus instruments on a single two-wire network up to 1200 m
(3900 ft) away. Can be increased using a repeater and/or standard RS-485 network
equipment.
Notes:
•
RS-485 wiring maximum length 1200 m (3900 ft)
Communication Settings
•
Protocol Type = Modbus RTU and Modbus ASCII
•
RTU Framing = Detect via Timing
•
Slave Response Timeout = 1000
•
Baudrate = selectable
•
Databits = 1
•
Parity = None
•
Stopbits = 1
7ML19985MA01
SITRANS RD500 – OPERATING INSTRUCTIONS
Page 37