Siemens SITRANS RD500 매뉴얼 - 페이지 8

{카테고리_이름} Siemens SITRANS RD500에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SITRANS RD500 11 페이지. Configuring sitrans rd500 for connection to multiranger with modbus rtu
Siemens SITRANS RD500에 대해서도 마찬가지입니다: 사용 설명서 (48 페이지), 사용 설명서 (8 페이지), 사용 설명서 (8 페이지), 사용 설명서 (8 페이지), 애플리케이션 매뉴얼 (6 페이지), 적용 사례 (9 페이지)

페이지 인쇄

Planning/configuring

3.3 Configuring RD500 to Read MODBUS Registers from MultiRanger

3.3

Configuring RD500 to Read MODBUS Registers from MultiRanger

1. Click on I/O > MODBUS: you should see the screen below.

2. In the RS485 Port section, set the Baud Rate to 19200, as shown above.

3. Click on the checkbox to enable a MODBUS device, and then enter a Name, e.g. MultiRanger

100. Set Node to 1 and click on Apply. (Another MODBUS device entry will appear below

the first one.)

– Be sure all serial communication settings are the same on both the RD500 and the

– Parameter P772 controls the baud rate of the MultiRanger. Be sure to select Port 2 for

4. Click on Configure to open the device node page for the MultiRanger, shown below.

MultiRanger (Baud, data bits, stop bits and parity).

RS485.

Configuring SITRANS RD500 for connection to MultiRanger with MODBUS RTU

Application examples, 09/2020, AG111710