Siemens SITRANS RD500 Handmatig - Pagina 8

Blader online of download pdf Handmatig voor {categorie_naam} Siemens SITRANS RD500. Siemens SITRANS RD500 11 pagina's. Configuring sitrans rd500 for connection to multiranger with modbus rtu
Ook voor Siemens SITRANS RD500: Gebruiksaanwijzing (48 pagina's), Gebruiksaanwijzing (8 pagina's), Gebruiksaanwijzing (8 pagina's), Gebruiksaanwijzing (8 pagina's), Toepassingshandleiding (6 pagina's), Toepassingsvoorbeelden (9 pagina's)

Planning/configuring

3.3 Configuring RD500 to Read MODBUS Registers from MultiRanger

3.3

Configuring RD500 to Read MODBUS Registers from MultiRanger

1. Click on I/O > MODBUS: you should see the screen below.

2. In the RS485 Port section, set the Baud Rate to 19200, as shown above.

3. Click on the checkbox to enable a MODBUS device, and then enter a Name, e.g. MultiRanger

100. Set Node to 1 and click on Apply. (Another MODBUS device entry will appear below

the first one.)

– Be sure all serial communication settings are the same on both the RD500 and the

– Parameter P772 controls the baud rate of the MultiRanger. Be sure to select Port 2 for

4. Click on Configure to open the device node page for the MultiRanger, shown below.

MultiRanger (Baud, data bits, stop bits and parity).

RS485.

Configuring SITRANS RD500 for connection to MultiRanger with MODBUS RTU

Application examples, 09/2020, AG111710