Cisco Unified 7905G 네트워크 설정 구성 - 페이지 13
{카테고리_이름} Cisco Unified 7905G에 대한 네트워크 설정 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Unified 7905G 34 페이지. Ip talk series
Cisco Unified 7905G에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지), 데이터시트 (5 페이지), 사용자 설명서 (25 페이지), 전화 매뉴얼 (46 페이지), 빠른 참조 (2 페이지), 사용자 설명서 (20 페이지), 참조 매뉴얼 (20 페이지)
페이지 인쇄
Chapter 4
Configuring Network Settings on the Cisco Unified IP Phone
Modifying DHCP Settings
Enabling DHCP
Step 1
Step 2
Step 3
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 4.2, Cisco Unified IP Phone
OL-8617-01
Dynamic Host Configuration Protocol (DHCP) automatically assigns IP
addresses to devices when you connect them to the network. This section provides
information about enabling DHCP and releasing a DHCP-assigned IP address in
the following topics:
Enabling DHCP, page 4-13
•
•
Disabling DHCP, page 4-15
Releasing a DHCP Address, page 4-16
•
Cisco Unified IP Phones enable DHCP by default, but you can reset the protocol
if it becomes disabled.
To enable DHCP for the Cisco Unified IP Phone, follow these steps:
For instructions, see the
In the pane on the left under Change Configuration, click Network Parameters.
The Network Parameters web page appears.
To enable DHCP, enter 1 in the DHCP field and click Apply.
"Accessing Network Settings through a Phone
4-2.
Modifying DHCP Settings
4-13