Cisco Unified IP Phone Expansion Module 7915 매뉴얼 - 페이지 11

{카테고리_이름} Cisco Unified IP Phone Expansion Module 7915에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Unified IP Phone Expansion Module 7915 27 페이지. Unified ip phone and expansion module for unified communications manager express 4.3 and later versions
Cisco Unified IP Phone Expansion Module 7915에 대해서도 마찬가지입니다: 빠른 참조 (2 페이지)

페이지 인쇄

Cisco Unified IP Phone Expansion Module 7915 매뉴얼

Insert the hooks into the slots and then rotate the top

Step 3

of the Cisco Unified IP Phone Expansion Module 7915

into the support bar so that it rests flush with the bar.

Tighten the thumbscrew on the back of the

Step 4

Cisco Unified IP Phone Expansion Module 7915.

Note

Connect the Interface Cable

Refer to Figure 5 which depicts the "in" and "out" icons on the

AUX jacks, and to and the steps that follow.

Figure 5

"In" and "Out" Icons on the AUX Jacks

In icon

Plug one end of the interface cable into the jack labeled

Step 1

AUX on the Cisco Unified IP Phone.

Plug the other end of the interface cable into the AUX

Step 2

jack with the "in" icon underneath on the

Cisco Unified IP Phone Expansion Module 7915.

Note

If you are installing two Expansion Modules,

repeat Steps 2, 3, and 4 for the second

Expansion Module.

Out icon

If you are installing a second Cisco Unified

IP Phone Expansion Module 7915, continue

with Steps 3 and 4. Otherwise go to the

"Connect the Power Supply Unit" section on

page 12.