Cisco Nexus 1000V 배포 매뉴얼 - 페이지 9

{카테고리_이름} Cisco Nexus 1000V에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Nexus 1000V 25 페이지. For microsoft hyper-v
Cisco Nexus 1000V에 대해서도 마찬가지입니다: 배포 매뉴얼 (49 페이지), 데이터시트 (8 페이지), 매뉴얼 (6 페이지), 설치 매뉴얼 (27 페이지)

페이지 인쇄

Deployment Guide

Figure 2.

Proper Virtual Supervisor Module Networking Configuration

Note:

Please refer to the Cisco Nexus 1000V Series Switches installation guide for detailed VSM installation

instructions.

Control Interface

The control interface is a Layer 2 interface used to communicate with the VEMs. This interface handles low-level

control packets such as heartbeats as well as any configuration data that needs to be exchanged between the VSM

and VEM. Because of the nature of the traffic carried over the control interface, it is the most important interface in

the Cisco Nexus 1000V Series solution.

The control interface is always the first interface on the VSM and is usually labeled "Network Adapter 1" in the virtual

machine network properties.

Management Interface

The management interface is the interface that appears as the mgmt0 port on a Cisco switch. As with the

management interfaces of other Cisco switches, an IP address is assigned to mgmt0. Although the management

interface is not used to exchange data between the VSM and VEM, it is used to establish and maintain the

connection between the VSM and VMware vCenter Server.

The management interface is always the second interface on the VSM and is usually labeled "Network Adapter 2" in

the virtual machine network properties.

Page 9 of 25