CAB WICON SQUIX 서비스 매뉴얼 - 페이지 6
{카테고리_이름} CAB WICON SQUIX에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB WICON SQUIX 18 페이지. Wrap-around applicator
페이지 인쇄2
Preparation
6
2.1
Tools
Do not use any worn of damaged tools.
Only use tools and testing devices that are suitable for the task at hand.
Standard tools:
•
Screw driver TX 10
•
Screw driver TX 20
•
Screw driver TX 25
•
Screw driver TX 30
•
Socket wrench 9
•
Allen key 2 mm
•
Allen key 2.5 mm
•
Open-end wrench 5
•
Snap ring pliers ZGG 0
•
Pointed pliers straight
•
Belt tension measuring device
cab special tools:
•
Calibration rod 10 mm (Part No. 5988543)
2.2
Removing the Applicator from the Printer
1
Fig. 1
Removing the applicator from the printer
Switch off the printer.
Loosen screw (2).
Remove the applicator from the printer. The plug of the applicator will be disconnected from the connector (1).
2
3
6