Cisco WUMC710 사용자 설명서 - 페이지 10

{카테고리_이름} Cisco WUMC710에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WUMC710 17 페이지. 802.11ac
Cisco WUMC710에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (17 페이지), 사용자 설명서 (17 페이지)

페이지 인쇄

Linksys WUMC710

WEP

WEP is a basic encryption method, which is not as secure as WPA or WPA2

Key 1

Enter the WEP key of your network

Tx Key

Key 1 is the transmit key used by the media connector

Authentication

The default is Open, which uses open system authentication,

so the sender and recipient do not use a WEP key for authentication Select

Shared to use shared key authentication, in which the sender and recipient

use a WEP key for authentication Select Auto to allow either Open system or

Shared key authentication to be used

Click Save Settings to apply your changes, or click Cancel Changes to cancel

your changes

Wi-Fi Protected Setup

There are two methods available Use the method that applies to the router

you are using

Method #1

Use this method if your router has a Wi-Fi Protected Setup button

1. Click or press the Wi-Fi Protected Setup button on the router

2. Within two minutes, click the Wi-Fi Protected Setup button on the

media connector's Wi-Fi Protected Setup screen

3. After the media connector has been configured, click Close

The Wi-Fi Protected Setup screen displays the Link Status, Network Name (SSID),

and Security method

Method #2

Use this method if your router requests the PIN number of the media connector

1. On the router's Wi-Fi Protected Setup screen, enter the PIN number on

the media connector's Wi-Fi Protected Setup screen Then click Register

or the appropriate button (It is also listed on the label on the bottom of

the media connector )

2. On the media connector's Wi-Fi Protected Setup screen, click OK

3. After the media connector has been configured, click Close

The Wi-Fi Protected Setup screen displays the Link Status, Network Name (SSID),

and Security method

Advanced Configuration