DigitaLinx DL-HD2100 빠른 설치 매뉴얼 - 페이지 5

{카테고리_이름} DigitaLinx DL-HD2100에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-HD2100 8 페이지. Hdbaset extender set
DigitaLinx DL-HD2100에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (8 페이지), 소유자 매뉴얼 (17 페이지)

페이지 인쇄

1. Verify all components included with the extender set are present before

installati on.

2. If the extenders are going to be permanently mounted to a surface, att ach the

included mounti ng brackets with the supplied screws.

3. Turn oﬀ power and disconnect the audio/video equipment by following the

manufacturer's instructi ons.

4. Connect Category 6 or greater twisted pair cable with RJ45 connectors between

the transmitt er and the receiver. TIA/EIA-568B straight-through wiring connecti ons

must be used with all HDBaseT extenders.

5. Connect an HDMI cable and any desired control accessories between the

display and the receiver.

6. Connect an HDMI cable and any desired control accessories between the source

and the transmitt er.

7. Connect the included power supply to the transmitt er or receiver and lock the

power supply to the power connector by twisti ng the locking collar clockwise.

8. Power on att ached audio/video devices.

Passing IR Signals:

The DL-HD2100 is capable of passing IR signals between 33 and 55 KHz. To

prevent damage to any of the electronics, the extenders should be powered oﬀ

while inserti ng or removing any IR components. Inserti ng an IR transmitt er into

the IR IN port may damage the IR circuit for that extender.

IR OUT: The IR transmitt er (IR emitt er) must be plugged into the IR OUT port.

IR IN: The IR receiver (IR eye) must be plugged into the IR IN port.

To connect to a 3rd party IR system such as a control system, connect the TS

connector of the IR-AC coupling cable to the IR output port of the control

system and connect the TRS connector of the IR-AC cable to the IR IN to either

transmitt er or receiver of the DL-HD2100.

Connecti vity Instructi ons