Cisco MERAKI MR72 설치 매뉴얼 - 페이지 10

{카테고리_이름} Cisco MERAKI MR72에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco MERAKI MR72 20 페이지.
Cisco MERAKI MR72에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (16 페이지)

Powering the MR72 with an 802.3af Power over Ethernet Switch

Route Ethernet cable from a port on an active 802.3af PoE switch to the Eth0 port in the bay of the MR72. The MR72 is

Gigabit Ethernet-capable. To maximize device performance, a Gigabit-capable switch should be used.

Verify Device Functionality and Test Network Coverage

1. Check LEDs

a. The Power LED should be solid green (or blue, if clients are connected). If it is ﬂashing blue, the ﬁrmware is

automatically upgrading and the LED should turn green when the upgrade is completed (normally within a

few minutes). See the

b. Note: Your MR72 must have an active route to the Internet to check and upgrade its ﬁrmware.

2. Verify access point connectivity

a. Use any 802.11 client device to connect to the MR72 and verify proper connectivity using the client's web

browser.

3. Check network coverage

4. Conﬁrm that you have good signal strength throughout your coverage area. You can use the signal strength meter

on a laptop, smart phone, or other wireless device.

Reference the

MR Product Page

Europe – EU Declaration of Conformity

This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test methods

have been applied in order to prove presumption of conformity with the essential requirements of the R&TTE Directive

1999/5/EC:

Radio: EN 300 328, EN 301 893

EMC: EN 301 489-1, EN 301 489-17

Safety: EN 60950-1

Exposure: EN 505385

Emissions: EN 55022, EN 61000-3-2,

EN 61000-3-3

Immunity: EN 61000-4-2, EN 61000-4-3,

EN 61000-4-4, EN 61000-4-5,

EN 61000-4-6, EN 61000-4-11

"LED

Indicators" section for more details. .

for additional information and troubleshooting tips.