Cisco MERAKI MR72 설치 매뉴얼 - 페이지 9

{카테고리_이름} Cisco MERAKI MR72에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco MERAKI MR72 20 페이지.
Cisco MERAKI MR72에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (16 페이지)

Attach Antennas

Remove protective plastic covers from all four N-type RF connectors. Attach appropriate antennas (and protective boots

if included).

Power the MR72

1. Route the Ethernet cable from the PoE Injector "OUT" port or from a PoE enabled switch to the MR72.

2. Install a Cable Gland on the MR72 end of the cable.

3. Plug the Ethernet cable into the Ethernet port of the Meraki MR72.

a. Connect the cable to the Ethernet port on the MR72.

b. Screw the gland body into the threaded hole of the port. Use an adjustable wrench to make sure the gland

body is fully seated in the hole.

c. Insert the split ring gasket into the gland body.

d. Screw the cap tightly onto the gland. You may need a wrench to fully tighten the cap, but take care not to

damage the cable in the process.

Powering the MR72 with the Meraki 802.3at Power over Ethernet Injector (sold separately)

1. Plug the power cord into the PoE Injector and the other end into wall power.

2. Plug an Ethernet cable that is connected to an active Ethernet connection into the "IN" port on the injector.

3. Route Ethernet cable from the "OUT" port on the injector to the Eth0 port in the cable bay of the MR72.