Cisco WAP361 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} Cisco WAP361에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WAP361 17 페이지. Reboot and reset to factory default settings
Cisco WAP361에 대해서도 마찬가지입니다: 매뉴얼 (4 페이지)
페이지 인쇄
For wall mounting, drill four pilot holes at the mounting hole
S
2
TEP
locations you have marked (at opposite corners of the bracket),
and use appropriate anchors as required.
The pilot hole size varies according to the material, and its
N
OTE
thickness, you are fastening. Cisco recommends that you test the
material to determine the ideal hole size for your mounting
application.
Feed the cable(s) from the junction box / wall through the large
S
3
TEP
center cable access hole in the bracket, with the words "NOTICE
WALL MOUNT ONLY" facing you as shown in
Figure 2
Bracket Mounting Direction
Position the mounting bracket mounting holes (with the words
S
4
TEP
"NOTICE WALL MOUNT ONL Y" facing you) over the screw holes.
Insert a screw into each mounting hole and tighten.
S
5
TEP
Screws supplied in kit (see
N
OTE
all
for
mounting options. You may need to obtain screws which fit
your custom installation.
6
Figure
Figure
3) may not be appropriate
Cisco WAP361 Quick Start Guide
2.