Cisco Wap581 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} Cisco Wap581에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Wap581 17 페이지. Reboot and reset to factory default settings
Cisco Wap581에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (14 페이지), 매뉴얼 (10 페이지)
페이지 인쇄
Insecure mounting might damage the device or cause injury. Cisco is not
W
ARNING
responsible for damages incurred by insecure wall or ceiling mounting.
Determine where you want to mount the device. Verify that the surface is
S
1
TEP
smooth, flat, dry, and sturdy.
Drill two pilot holes into the surface 2.75 inches (70 mm) apart for your Cisco
S
2
TEP
WAP device.
Insert a screw into each hole, leaving a gap between the surface and the base
S
3
TEP
of the screw head.
Place the upper slots of the bracket over the screws, adjust the screws
S
4
TEP
accordingly, and slide the bracket down until the screws fit snugly into the
slots.
Using the bracket as a template, drill two more holes for the lower screws.
S
5
TEP
Insert a screw into each lower hole.
S
6
TEP
Cisco WAP125 Quick Start Guide
5