Cisco TelePresence SpeakerTrack 60 카메라 매뉴얼 - 페이지 15
{카테고리_이름} Cisco TelePresence SpeakerTrack 60에 대한 카메라 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence SpeakerTrack 60 40 페이지. Telepresence
Cisco TelePresence SpeakerTrack 60에 대해서도 마찬가지입니다: 데이터시트 (3 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (14 페이지), 매뉴얼 (22 페이지), 카메라 매뉴얼 (44 페이지)
페이지 인쇄
Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents
Connect Quad Camera to SX80 Codec
•
Connect the HDMI cable between the camera and the codec. The
cable transmits video from the camera to the codec.
Codec: Always use Connector 1 (HDMI input) for the main camera.
Camera: Connect to connector 1 (HDMI output).
•
Connect the camera control cable (Ethernet) between the camera
control ports on the camera and codec.
Codec: Connect to the codec's 2nd or 3rd Ethernet port.
Camera: The connector is marked with the camera control symbol.
Connect a network switch to the codec's 2nd or 3rd Ethernet port
if you need more than two ports to support your device.
•
Connect the audio cable between the loudspeaker output on the
codec and the line input on the Quad Camera. The cable trans-
mits audio from the codec to the loudspeakers in the camera.
•
Connect the power adapter to the camera and connect to power.
•
Connect other codec cables as described in
TelePresence SX80 Integrator Package with Quad Camera
Installation Guide.
RJ45
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction
Physical interface
theCisco
HDMI
Connecting to a codec
Connecting to a codec
3.5 mm
Euroblock
3.5 mm
mini-jack,
3-pin
Power
(100-240 V
, 50/60 Hz)
AC
15
Factory reset
Appendix
Power
adapter
Always use the provided power cable
and adapter.
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide