Cisco TelePresence SpeakerTrack 60 Instrukcja obsługi kamery - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja obsługi kamery dla System konferencyjny Cisco TelePresence SpeakerTrack 60. Cisco TelePresence SpeakerTrack 60 40 stron. Telepresence
Również dla Cisco TelePresence SpeakerTrack 60: Arkusz danych (3 strony), Instrukcja instalacji (19 strony), Instrukcja instalacji (14 strony), Podręcznik (22 strony), Instrukcja obsługi kamery (44 strony)
Drukuj stronę
Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents
Connect Quad Camera to SX80 Codec
•
Connect the HDMI cable between the camera and the codec. The
cable transmits video from the camera to the codec.
Codec: Always use Connector 1 (HDMI input) for the main camera.
Camera: Connect to connector 1 (HDMI output).
•
Connect the camera control cable (Ethernet) between the camera
control ports on the camera and codec.
Codec: Connect to the codec's 2nd or 3rd Ethernet port.
Camera: The connector is marked with the camera control symbol.
Connect a network switch to the codec's 2nd or 3rd Ethernet port
if you need more than two ports to support your device.
•
Connect the audio cable between the loudspeaker output on the
codec and the line input on the Quad Camera. The cable trans-
mits audio from the codec to the loudspeakers in the camera.
•
Connect the power adapter to the camera and connect to power.
•
Connect other codec cables as described in
TelePresence SX80 Integrator Package with Quad Camera
Installation Guide.
RJ45
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction
Physical interface
theCisco
HDMI
Connecting to a codec
Connecting to a codec
3.5 mm
Euroblock
3.5 mm
mini-jack,
3-pin
Power
(100-240 V
, 50/60 Hz)
AC
15
Factory reset
Appendix
Power
adapter
Always use the provided power cable
and adapter.
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide