Cisco TelePresence SpeakerTrack 60 Instrukcja obsługi kamery - Strona 30
Przeglądaj online lub pobierz pdf Instrukcja obsługi kamery dla System konferencyjny Cisco TelePresence SpeakerTrack 60. Cisco TelePresence SpeakerTrack 60 40 stron. Telepresence
Również dla Cisco TelePresence SpeakerTrack 60: Arkusz danych (3 strony), Instrukcja instalacji (19 strony), Instrukcja instalacji (14 strony), Podręcznik (22 strony), Instrukcja obsługi kamery (44 strony)
Drukuj stronę
Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents
Quad Camera
A factory reset should only be performed by a system
administrator or in contact with Cisco technical support.
The camera will be reset to factory defaults, and all configu-
ration and logs will be erased.
It is not possible to undo a factory reset.
To perform a factory reset:
1. Locate the pinhole button at the back of the camera.
2. Use a pen or similar to press and hold the factory reset
button for about 6 seconds, until the white LED at the
front of the camera starts blinking.
3. The system restarts two times to complete the factory
reset operation. This procedure may take up to 5 minutes,
depending on the software version.
4. The white LED will start pulsing normally once the fac-
tory reset operation is complete and the unit is starting
normally.
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction
Physical interface
Connecting to a codec
Pinhole for
factory reset
30
Factory reset
Factory reset
Appendix
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide