Cisco TelePresence SpeakerTrack 60 Camera Manual - Page 30
Browse online or download pdf Camera Manual for Conference System Cisco TelePresence SpeakerTrack 60. Cisco TelePresence SpeakerTrack 60 40 pages. Telepresence
Also for Cisco TelePresence SpeakerTrack 60: Datasheet (3 pages), Installation Manual (19 pages), Installation Manual (14 pages), Manual (22 pages), Camera Manual (44 pages)
Print Page
Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents
Quad Camera
A factory reset should only be performed by a system
administrator or in contact with Cisco technical support.
The camera will be reset to factory defaults, and all configu-
ration and logs will be erased.
It is not possible to undo a factory reset.
To perform a factory reset:
1. Locate the pinhole button at the back of the camera.
2. Use a pen or similar to press and hold the factory reset
button for about 6 seconds, until the white LED at the
front of the camera starts blinking.
3. The system restarts two times to complete the factory
reset operation. This procedure may take up to 5 minutes,
depending on the software version.
4. The white LED will start pulsing normally once the fac-
tory reset operation is complete and the unit is starting
normally.
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction
Physical interface
Connecting to a codec
Pinhole for
factory reset
30
Factory reset
Factory reset
Appendix
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide