Sony BRC-X401 명령 목록 - 페이지 13

{카테고리_이름} Sony BRC-X401에 대한 명령 목록을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony BRC-X401 41 페이지. Srt introduction
Sony BRC-X401에 대해서도 마찬가지입니다: 매뉴얼 (15 페이지), 기술 매뉴얼 (15 페이지)

페이지 인쇄

because of limitations of order to receive commands or execution interval of command. It may cause

efficiency to be reduced substantially.

Timing chart

Controller

Time out

Timing chart (loss of command)

Controller

Time out

Timing chart (loss of ACK or completion message)

Limitation

The following are limitations for VISCA over IP as

compared with the VISCA specifications.

Locking the peripheral device's address of the

VISCA message to 1

VISCA over IP cannot reflect each address to the

address of the VISCA message because up to 112

peripheral devices and 5 controllers are

connected. Because of this, the peripheral

device's address of VISCA command is locked to

1 when using VISCA over IP. If the peripheral

device's address is set to other than 1 for the

VISCA command, the peripheral device works

without hindrance since the peripheral device

recognizes that its address is set to 1.

Peripheral device

Locking the controller's address of the VISCA

message to 0.

For the same reason as the peripheral device's

address, the controller's address of VISCA

command is locked to 0. If the controller's

address is set to other than 0, the peripheral

device works without hindrance, and the reply

address from the peripheral device is always set

to 0.

Prohibition of specifying the broadcast

address for the VISCA message

Do not use the broadcast address because it

requires the serial communication. Operations

under the broadcast address is set to the

command are not guaranteed.

Peripheral device

Prohibition of the Address Set for VISCA device

setting command

Do not use this command because it requires the

serial communication. Operations under the

Address Set command is sent are not

guaranteed.

VISCA Network Change command is not

supported

This cannot be issued because it requires the

serial communication.

Expiration time for an on status of the tally

lamp

The tally lamp is turned off if not receiving an ON

command from any controller for 15 seconds

after receiving an ON command of TALLY ON/

OFF.