Cisco 6160 설치 절차 매뉴얼 - 페이지 14

{카테고리_이름} Cisco 6160에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6160 32 페이지. Without a pots splitter configuration
Cisco 6160에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (38 페이지), 하드웨어 설치 매뉴얼 (21 페이지), 설치 및 교체 참고 사항 (18 페이지)

페이지 인쇄

Installation Procedures

4.2.6 Connect the Alarm Contacts

This step is optional.

Note

Complete the following steps to connect an external alarm device to the wire-wrap pins on the I/O card:

The relay for the circuit-breaker trip alarm is wired through the small green terminal blocks (BRKR 1

Note

and BRKR 2) on the chassis backplane and not through the wire-wrap connector.

Caution

Use extreme caution when wire-wrapping the pin connections for the STAT_ALARMS and

BITS_A/BITS_B pins. Incorrect wire connections will cause damage to the equipment.

Step 1

Measure wire long enough to connect the appropriate pin to the external alarm device. See

wire specifications.

Note

Use a wire stripper to remove the casing from both ends of the wire.

Step 2

Use a wire-wrapping tool to attach the wire to the appropriate pin.

Step 3

Use a wire-wrapping tool to attach the other end of the wire used in

Step 4

Step 5

Repeat

Step 6

Repeat

Cisco 6160 Hardware Installation Guide

4-14

See the

"I/O Cards" section on page 1-43

I/O card. See

Appendix C, "Connector and Pinout Specifications,"

Step 1

through

Step 4

to wire wrap all necessary pins.

Step 1

through

Step 5

for each Cisco 6160 chassis being installed.

Chapter 4

Installing a Cisco 6160 Without a POTS Splitter Configuration

for an illustration of the pinouts that are located on the

Step 3

Table 2-4

for

for pinout descriptions.

to the external alarm device.

OL-2190-02 B0