Cisco Aironet 340 Series 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Cisco Aironet 340 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 340 Series 12 페이지. Usb client adapter
Cisco Aironet 340 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (13 페이지), 릴리스 정보 (14 페이지), 빠른 시작 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄

Connect and Power Up the Bridge

Note: Before you install the bridge system, we recommend that you test the bridge using the

2.2 dBi antenna included in the package. Then install the wireless bridge with the appropriate

antenna for your application. A lightning arrestor and low-loss antenna cable are included in

the optional antenna kits or can be ordered separately.

Installing the Antenna

If applicable, with the unit powered off, attach a lightning arrestor to the antenna

connector.

Note: The lightning arrestor provides surge protection to the bridge in the event of a lightning

strike and is highly recommended if the antenna will be located outdoors.

Antenna connector

Connect one end of the low-loss antenna cable to the lightning arrestor connected to the

bridge antenna connector.

Note: Because of FCC and DOC regulations, the antenna connector on the Aironet bridge is

of reverse polarity to the standard TNC connectors.

Connect the other end of the antenna cable to the 2.2 dBi antenna or to an external

high-gain antenna.

Mount the bridge antenna at an appropriate elevation to ensure maximum path clearance

and line-of-sight to the other bridge or device.

Installing the Ethernet Connection

The Aironet wireless Ethernet bridge supports three connection types: 10Base2 (Thinnet),

10Base5 (Thicknet), or 10BaseT (twisted pair). Connect only one Ethernet cable to each

bridge. With the power off, connect the appropriate cable from your network to the bridge.

1 0 B a s e