Cisco Aironet 340 Series 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} Cisco Aironet 340 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 340 Series 12 페이지. Usb client adapter
Cisco Aironet 340 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (13 페이지), 릴리스 정보 (14 페이지), 빠른 시작 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (12 페이지)
페이지 인쇄
Installing the Console Port and Powering Up the Bridge
The console port and power connections are on the side of the bridge. The console connection
is required for setting up initial configuration information. After configuration is complete, you
may remove this cable unless or until additional configuration is required via the serial port.
1 2 -1 8 V D
4
Installing the Console Port Cable
Note: Use a straight-through cable with
9-pin male to 9-pin female connectors.
1
Attach the console port cable to the
console port on the bridge.
2
Attach the other end of the console cable
to the serial port on a terminal or PC
running a terminal emulation program.
3
Set the terminal to 9600 baud, 8 data
bits, No parity, 1 stop bit, and Xon/Xoff
flow control.
C
E /R S -2 3 2
C O N S O L
C
Power connector
On/off button
E/R S-2 32C
CO NS OL
C
12- 18 VD
I
Connecting Power to the Bridge
1
Connect the small plug on the end of the
power pack cord into the bridge power
port.
2
Plug the power pack into an electrical
outlet (120VAC/60 Hz or
90–264VAC/47–63 Hz, as appropriate).
3
Push the on/off button to power on the
bridge.
When power is initially applied to the
bridge, all three indicators on the top
panel will flash in sequence to test the
functionality of the indicators.
C
E /R S -2 3 2
C O N S O L
C
1 2 -1 8 V D
Console port