DIGITEN WTC200 사용자 설명서 - 페이지 6

{카테고리_이름} DIGITEN WTC200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGITEN WTC200 12 페이지.
DIGITEN WTC200에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지), 사용자 설명서 (9 페이지)

receiver.

2, Press and hold

button, the LED flashes 5 times, then flash 2

times quickly before release the button. All remotes will be unpaired.

If you repair the remote, please repeat the step 1.

Note： A remote can control multiple receivers.

Change the temperature unit

Press the

button for 3 seconds to switch the temperature unit.

Cooling mode

Set the temperature value RUN>STOP, the controller is in cooling

mode, and the LCD displays the COOLING symbol

1.1 When the CURRENT temperature value is higher than the RUN

value, the cooling operation starts, the relay outputs, the LCD displays

, and the green light on the receiver is on. When the CURRENT

value drop to the STOP value, the cooling operation stops, and the

LCD displays

. The green light on the receiver is off.

1.2 When the CURRENT temperature value is less than the RUN

value, the cooling operation stops, the relay has no output, the LCD

displays

, the green light on the receiver is off. When the

CURRENT value rises to the RUN value, the cooling operation starts,

the LCD displays

, the green light on the receiver is on.