DIGITEN WTC200 사용자 설명서 - 페이지 8

{카테고리_이름} DIGITEN WTC200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGITEN WTC200 12 페이지.
DIGITEN WTC200에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지), 사용자 설명서 (9 페이지)

according to the previous setting value until 5 minutes.

Delay function

Damage can occur if the compressor restarted too soon after

shutdown. This feature forces the compressor to wait for a few

minutes before restarting.

During the waiting time, the display will flash

waiting time has elapsed, the display stop flashing and the compressor

turns on

How to set

1. Press and hold the SET button until the corresponding value flashes.

At the same time, the

button to change the number. Short press SET button to

set next valve, or long press the SET button to exit and save. use this

method to set the RUN /STOP /Delay/ HIGH /LOW value

respectively. Or after setting all the parameters, press and hold the

SET button to exit and save. When no operation time is greater

than 30 seconds in the setting state, the exit setting mode is not

saved.

NOTE, in the setting state, long press the UP or DOWN button to

continuously to change the setting value

is displayed on the LCD. Press the

, When the safe