Cisco ASA 5506W-X 구성 매뉴얼 - 페이지 7

{카테고리_이름} Cisco ASA 5506W-X에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506W-X 13 페이지. Threat defense reimage guide
Cisco ASA 5506W-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (14 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (12 페이지), 설치 매뉴얼 (46 페이지), 섀시 마운트 (10 페이지)

ASA by pressing CTRL + SHIFT + 6 +X (CTRL ^ X).

Once the SFR configuration applies, you must be able to ping the SFR management IP address

from the ASA:

asa# ping 10.2.0.254

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.2.0.254, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms

asa#

If you cannot ping the interface successfully, verify the configuration and state of physical ethernet

connections.

Step 8. Connect to AP GUI to enable radios and set other WAP configuration

At this point you should have connectivity to manage the WAP via the HTTP GUI as discussed in

the quick start guide. You will either need to browse to the IP address of the WAP's BVI interface

from a web browser of a client that is connected to the inside network on the 5506W or you can

apply the example configuration and connect to the SSID of the WAP. If you do not use the CLI

below, you need to plug in the ethernet cable from your client to the Gigabit1/2 interface on the

ASA.

If you prefer to use the CLI to configure the WAP, you can session into it from the ASA and use

this example configuration. This creates an open SSID with the name of 5506W and 5506W_5Ghz

so that you can use a wireless client to connect to and further manage the WAP.

Note: After applying this configuration you will want to access the GUI and apply security to

the SSIDs so that the wireless traffic is encrypted.

WAP CLI Configuration for a single wireless VLAN using modified IP ranges

dot11 ssid 5506W

authentication open

guest-mode

dot11 ssid 5506W_5Ghz

authentication open

guest-mode

interface Dot11Radio0

ssid 5506W

interface Dot11Radio1

ssid 5506W_5Ghz

interface BVI1

ip address 10.1.0.254 255.255.255.0

ip default-gateway 10.1.0.1

interface Dot11Radio0

no shut

interface Dot11Radio1