Cisco ASA 5506W-X 구성 매뉴얼 - 페이지 8

{카테고리_이름} Cisco ASA 5506W-X에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506W-X 13 페이지. Threat defense reimage guide
Cisco ASA 5506W-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (14 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (12 페이지), 설치 매뉴얼 (46 페이지), 섀시 마운트 (10 페이지)

no shut

From this point on, you can perform the normal steps to complete the configuration of the WAP

and you must be able to access it from the web browser of a client connected to the above created

SSID. The default username of the access point is Cisco with a password of Cisco with a capital

Cisco ASA 5506-X Series Quick Start Guide

http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/5506X/5506x-quick-start.html#pgfId-

138410

You need to use the IP address of 10.1.0.254 instead of the 192.168.10.2 as stated in the Quick

Start Guide.

Configurations

The resulting configuration must match the output (assuming you used the example IP ranges,

otherwise substitute accordingly:

ASA Configuration

Interfaces:

Note: The lines in italics only apply if you do NOT have an inside switch:

asa# sh run interface gigabitEthernet 1/2

interface GigabitEthernet1/2

nameif inside

security-level 100

ip address 10.0.0.1 255.255.255.0

asa# sh run interface gigabitEthernet 1/3

interface GigabitEthernet1/3

nameif sfr

security-level 100

ip address 10.2.0.1 255.255.255.0 asa# sh run interface gigabitEthernet 1/9

interface GigabitEthernet1/9

nameif wifi

security-level 100

ip address 10.1.0.1 255.255.255.0

asa#

DHCP:

asa# sh run dhcpd

dhcpd auto_config outside **auto-config from interface 'outside' **auto_config dns x.x.x.x

x.x.x.x <-- these lines will depend on your ISP **auto_config domain isp.domain.com <-- these

lines will depend on your ISP ! dhcpd address 10.0.0.2-10.0.0.100 inside dhcpd dns 10.0.0.250

interface inside dhcpd enable inside ! dhcpd address 10.1.0.2-10.1.0.100 wifi dhcpd dns

10.0.0.250 interface wifi dhcpd enable wifi ! asa#

HTTP:

asa# show run http

http server enable

http 0.0.0.0 0.0.0.0 outside