Cisco ASR 5500 설치 매뉴얼 - 페이지 2

{카테고리_이름} Cisco ASR 5500에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 5500 31 페이지.
Cisco ASR 5500에 대해서도 마찬가지입니다: 설치 절차 개요 (6 페이지)

Using the CLI to View Status LEDs

Status LEDs for all cards can be viewed via the CLI by entering the Exec mode show leds all command.

[local]host_name#

The following displays a sample of this command's output.

Slot 01: Run/Fail: Green | Active: Off

Slot 02: Run/Fail: Green

Slot 03: Run/Fail: Green

Slot 05: Run/Fail: Green

Slot 06: Run/Fail: Green

Slot 08: Run/Fail: Green

Slot 11: Run/Fail: Green

Service: Off

Slot 12: Run/Fail: Green

Service: Off

Slot 13: Run/Fail: Green

Slot 14: Run/Fail: Green

Slot 15: Run/Fail: Green

Slot 16: Run/Fail: Green

Slot 17: Run/Fail: Green

The status of the two Power Filter Units (PFUs) can be viewed by entering the Exec mode show power chassis

command.

Each PFU has four LEDs along the top edge of its front panel. You must unsnap the top front cover from the

chassis to view these LEDs. Each LED is associated with one of the four -48 VDC power feeds connected to

the PFU.

Each LED on the PFU should illuminate blue for normal operating conditions.

Figure 1: PFU LEDs

The possible states for these LEDs are described in the following table. If the LED is not blue, use the

troubleshooting information below to diagnose the problem.

Troubleshooting

show leds all

| Active: Off

| Active: Green

| Active: Off

| Active: Green

| Redundant: Green

Troubleshooting

Master: Green

Master:Off

Status: Green