ACU-RITE SENC 150 설치 매뉴얼

{카테고리_이름} ACU-RITE SENC 150에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACU-RITE SENC 150 8 페이지. Chevalier fsg-2a 1224 surface grinder cross feed “x” axis
ACU-RITE SENC 150에 대해서도 마찬가지입니다: 참조 매뉴얼 (20 페이지), 설치 매뉴얼 (4 페이지), 설치 매뉴얼 (6 페이지), 사용 설명서 (12 페이지)

페이지 인쇄

SENC 150

Longitudinal Installation ...

Supplied with encoder hardware

**Supplied with center support hardware

Mounting Information...

These are application instructions for mounting the

longitudinal "X" axis SENC 150 encoder.

Before proceeding:

Please read the instructions completely.

Mount X axis prior to installing the cross feed.

Insure that the correct length encoder is being used

for the total axis travel.

Keep the reading head centered during installation.

Clean the mounting surfaces.

Save the alignment brackets with the Encoder

Reference Manual after installation is completed.

First Steps ...

Machine

Move the table to its center of travel.

Mark the axis so that it can be re-centered easily.

Move the saddle completely forward on the knee.

P.N. 385072-208 Ed B 2/06

Encoder Installation Manual For: Vertical Knee Mill

Stop

Reading head bracket

* 1/4-20 x 1" BHCS (2)

Encoder

Unpack encoder in a safe, convenient location.

Do not remove the reading head alignment

brackets until instructed.

Center reading head ...

•

Slide the reading head and brackets along the scale

case until the center marks on the scale case and

reading head are aligned.

Installation Manual 385072-38

Longitudinal X Axis on Rear of Table

5/16-18 x 3/4" SHCS

Encoder

** Center support

* 8-32 x 5/8" SHCS

(2)

1/4" Heavy flat washer

(2) .09" thick

Alignment bracket (2)

* M6 Flat washer (2)

.017" thick

** M6 Flat washer

.017" thick

** 1/4-20 x 3/4" BHCS

1/4-20 x 3/4" BHCS (2)

Align

center

marks

Acu-Rite Companies Inc.