ACU-RITE SENC 150 설치 매뉴얼 - 페이지 4
{카테고리_이름} ACU-RITE SENC 150에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACU-RITE SENC 150 8 페이지. Chevalier fsg-2a 1224 surface grinder cross feed “x” axis
ACU-RITE SENC 150에 대해서도 마찬가지입니다: 참조 매뉴얼 (20 페이지), 설치 매뉴얼 (4 페이지), 설치 매뉴얼 (6 페이지), 사용 설명서 (12 페이지)
페이지 인쇄SENC 150
Table
Saddle
•
Attach the reading head bracket to the saddle, and
align the bracket tapped holes to the reading head
mounting holes.
•
Secure the bracket in place.
Leveling screw adjustment ...
*Leveling set screw
(3)
Gap
•
A gap will exist between the reading head and the
bracket.
•
Insert the two *8-32 x 5/8" SHCS. Insure the bracket
is adjusted to provide proper screw head clearance.
Do Not Tighten Screws at this time.
•
Set each leveling set screw by placing a .001" - .003"
feeler gage between the set screw and the bracket.
•
Adjust each set screw until a slight drag is felt on the
feeler gage.
•
Evenly tighten the two 8-32 SHCS.
Installation Manual 385072-38
Reading head bracket
1/4-20 x 3/4" BHCS
and flat washer (.09 thk)
* 8-32 x 5/8" SHCS (2)
Acu-Rite Companies Inc.
One Precision Way • Jamestown, NY 14701
4
Encoder Installation Manual For: Vertical Knee Mill
Longitudinal X Axis on Rear of Table
Encoder button up ...
Slide brackets back
away from the
reading head and
cable
•
Use allen wrench from set screw adjustment to slide
alignment brackets away from the reading head.
•
Remove alignment brackets and save.
•
Move the axis through its full travel. Confirm that
the assembly does not interfere with the machine
movement.
Proceed with the Cross
Feed installation
Twist brackets
45° to remove
P.N. 385072-208 Ed B 2/06