Cisco TelePresence MCU 4200 Series 시작하기 - 페이지 7

{카테고리_이름} Cisco TelePresence MCU 4200 Series에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence MCU 4200 Series 18 페이지. Accessing conferences
Cisco TelePresence MCU 4200 Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (15 페이지)

페이지 인쇄

Initial configuration

Step one: Connect to the console port

Ensure power is connected to the MCU and the Status LED is green.

Connect the console port of the MCU to the serial port of your PC using the

blue RJ45 to DB9 cable supplied.

Use a serial terminal program, such as Secure CRT or HyperTerminal, to

connect to the MCU. Set your terminal software to the following settings:

Baud rate:



Data bits:



Parity:



Stop bits:



Flow control: none



Press Enter and the following command prompt appears on the terminal:

MCU:>

Step two: Configure Ethernet Port A settings

The default setting for the MCU Ethernet ports is auto-sensing mode. If the switch

ports to which you connect the MCU are not also set to auto-sensing mode, then you

need to configure the MCU Ethernet ports to use the same speed and duplex mode.

Only connect to Ethernet Port B if you need to connect the MCU to a

second subnet.

Both ends of the Ethernet connection must be configured in the same

way. For example, either configure both ends of the link to be auto-

sensing or configure both ends to operate at the same speed and duplex.

To establish a 1000Mbps connection, both ends of the link must be

configured as auto-sensing.

38400

none

Initial configuration