Cisco TelePresence MCU 4200 Series Começar a trabalhar - Página 7
Procurar online ou descarregar pdf Começar a trabalhar para Hardware de rede Cisco TelePresence MCU 4200 Series. Cisco TelePresence MCU 4200 Series 18 páginas. Accessing conferences
Também para Cisco TelePresence MCU 4200 Series: Manual de iniciação (15 páginas)
Imprimir página
Initial configuration
Step one: Connect to the console port
1
Ensure power is connected to the MCU and the Status LED is green.
2
Connect the console port of the MCU to the serial port of your PC using the
blue RJ45 to DB9 cable supplied.
3
Use a serial terminal program, such as Secure CRT or HyperTerminal, to
connect to the MCU. Set your terminal software to the following settings:
Baud rate:
Data bits:
Parity:
Stop bits:
Flow control: none
4
Press Enter and the following command prompt appears on the terminal:
MCU:>
Step two: Configure Ethernet Port A settings
The default setting for the MCU Ethernet ports is auto-sensing mode. If the switch
ports to which you connect the MCU are not also set to auto-sensing mode, then you
need to configure the MCU Ethernet ports to use the same speed and duplex mode.
Only connect to Ethernet Port B if you need to connect the MCU to a
i
second subnet.
Both ends of the Ethernet connection must be configured in the same
i
way. For example, either configure both ends of the link to be auto-
sensing or configure both ends to operate at the same speed and duplex.
To establish a 1000Mbps connection, both ends of the link must be
i
configured as auto-sensing.
38400
8
none
1
Initial configuration
7