Cisco TelePresence MCU 4200 Series Pierwsze kroki - Strona 7
Przeglądaj online lub pobierz pdf Pierwsze kroki dla Sprzęt sieciowy Cisco TelePresence MCU 4200 Series. Cisco TelePresence MCU 4200 Series 18 stron. Accessing conferences
Również dla Cisco TelePresence MCU 4200 Series: Podręcznik dla początkujących (15 strony)
Drukuj stronę
Initial configuration
Step one: Connect to the console port
1
Ensure power is connected to the MCU and the Status LED is green.
2
Connect the console port of the MCU to the serial port of your PC using the
blue RJ45 to DB9 cable supplied.
3
Use a serial terminal program, such as Secure CRT or HyperTerminal, to
connect to the MCU. Set your terminal software to the following settings:
Baud rate:
Data bits:
Parity:
Stop bits:
Flow control: none
4
Press Enter and the following command prompt appears on the terminal:
MCU:>
Step two: Configure Ethernet Port A settings
The default setting for the MCU Ethernet ports is auto-sensing mode. If the switch
ports to which you connect the MCU are not also set to auto-sensing mode, then you
need to configure the MCU Ethernet ports to use the same speed and duplex mode.
Only connect to Ethernet Port B if you need to connect the MCU to a
i
second subnet.
Both ends of the Ethernet connection must be configured in the same
i
way. For example, either configure both ends of the link to be auto-
sensing or configure both ends to operate at the same speed and duplex.
To establish a 1000Mbps connection, both ends of the link must be
i
configured as auto-sensing.
38400
8
none
1
Initial configuration
7