Cisco UCS B200 M3 매뉴얼 - 페이지 3

{카테고리_이름} Cisco UCS B200 M3에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B200 M3 8 페이지. Blade server
Cisco UCS B200 M3에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 설치 및 서비스 참고 사항 (36 페이지), 설치 및 서비스 참고 사항 (37 페이지), 업그레이드 매뉴얼 (21 페이지), 설치 및 서비스 참고 사항 (28 페이지)

Install fNIC Drivers

This guide assumes that the UCS 2 .1 .2a or later fNIC drivers have been installed and are running . Please see the Cisco

UCS Manager Install and Upgrade Guides, Virtual Interface Card Drivers section, for complete driver installation instructions:

http://www .cisco .com/c/en/us/support/servers-unified-computing/ucs-manager/products-installation-guides-list .html

In addition, please review the Cisco UCS Hardware Compatibility List (HCL) to confirm hardware, operating system, and driver

compatibility:

http://www .cisco .com/en/US/products/ps10477/prod_technical_reference_list .html

Description: The total number of I/O requests that can be outstanding on a per-LUN basis .

Parameter name: fnic_max_qdepth

Default value: 32

Configuration capabilities:

• Boot Time

» Requires reboot for changes to take effect .

» Changes are persistent across reboots .

• Load Time

» Disruptive to SAN attached storage .

» Requires stopping SAN I/O, removing fNIC module dependencies, and removing and reloading the fNIC module .

» Not possible with the Boot from SAN configuration .

» Changes are nonpersistent across reboots .

• Run Time

» Nondisruptive .

» Changes apply only to newly discovered LUNs after modification .

» Changes are nonpersistent across reboots .