Cisco AS5300 - Universal Access Server 매뉴얼 - 페이지 20
{카테고리_이름} Cisco AS5300 - Universal Access Server에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AS5300 - Universal Access Server 21 페이지. Access server
Cisco AS5300 - Universal Access Server에 대해서도 마찬가지입니다: 부록 (10 페이지), 빠른 시작 매뉴얼 (25 페이지), 구성 매뉴얼 (46 페이지)
페이지 인쇄
Step 3 Install the safety ground (green wire) into the terminal block ground connector and
tighten the locking screw. Ensure that no bare wire is exposed.
Caution
Do not overtorque the terminal block contact screws. The recommended torque is 8.2 ± 0.4 inch-
lb.
Step 4 Insert the +48 VDC wire into the terminal block positive connector (+) and tighten the
locking screw. Ensure that no bare wire is exposed.
Step 5 Insert the -48 VDC wire into the terminal block negative connector (-) and tighten the
locking screw. Ensure that no bare wire is exposed.
Step 6 Secure the power supply cord to the cable strain-relief clamps on the DC power supply
with cable ties.
Warning
After wiring the DC power supply, remove the tape from the circuit breaker switch handle and
reinstate power by moving the handle of the circuit breaker to the ON position.
Step 7 Power ON the access server.
The internal power supply fan should power on.
Figure 3-15 DC Power Supply Connections