Cisco Firepower 2130 설치 및 유지 관리 - 페이지 24

{카테고리_이름} Cisco Firepower 2130에 대한 설치 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 2130 26 페이지. Rack-mount and ground the chassis
Cisco Firepower 2130에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지), 배포 매뉴얼 (8 페이지), 시작하기 (42 페이지)

페이지 인쇄

Install the FIPS Opacity Shield in a Four-Post Rack

When you toggle the power switch from ON to OFF, it takes several seconds for the system to power

Note

down. Do not remove the power cable until the power LED is off. After removing power from the chassis

either by moving the power switch to OFF or unplugging the power cord, wait at least 10 seconds before

turning power back ON.

Step 4

Route the cables through the openings in the cable management brackets (see figure below).

Step 5

Attach the FIPS opacity shield to the cable management brackets using the four 8-32 x 0.375 inch Phillips screws

provided in the FIPS kit.

Figure 13: Route the Cables and Attach the Screws

FIPS opacity shield

Cable management bracket

Step 6

Before you attach the TELs, clean the chassis of any grease, dirt, or oil with alcohol-based cleaning pads.

Step 7

Attach the seven TELs. See the figure below for the correct placement. Allow the TELs to cure for a minimum of 12

hours.

Caution

Any deviation in the placement of the TELs means the chassis is not in FIPS mode.

Installation, Maintenance, and Upgrade

8-32 x 0.375 inch-Phillips screws (two per side)