Cisco Firepower 2130 설치 및 유지 관리 - 페이지 25

{카테고리_이름} Cisco Firepower 2130에 대한 설치 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 2130 26 페이지. Rack-mount and ground the chassis
Cisco Firepower 2130에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지), 배포 매뉴얼 (8 페이지), 시작하기 (42 페이지)

페이지 인쇄

Installation, Maintenance, and Upgrade

Figure 14: TELs Placement on the Chassis

TEL 1 on the left side and top of chassis

TEL 3 on the top and back of chassis

TEL 5 across the FIPS shield and the chassis (towards

the right of the chassis)

TEL 7 on the bottom of the chassis towards the right

side of the chassis

Step 8

Attach the power cable to the chassis and connect it to an electrical outlet.

Step 9

Press the power switch on the rear panel.

Step 10

Check the power LED on the front panel. See

indicates that the chassis is powered on.

Step 11

Place the chassis in FIPS mode.

See the following procedures for how to place the chassis in FIPS mode:

•

ASA in Platform Mode

•

ASA in Appliance mode

•

FTD managed by FMC

Install the FIPS Opacity Shield in a Four-Post Rack

TEL 2 on the right side and top of chassis

TEL 4 across the FIPS shield and the chassis (towards

the left of the chassis)

TEL 6 on the bottom of the chassis towards the left

side of the chassis

—

Front Panel LEDs

for a description of the power LED. Solid green

Installation, Maintenance, and Upgrade