Cisco SCE8000 GBE 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Cisco SCE8000 GBE에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE8000 GBE 25 페이지. 10gbe platform
Cisco SCE8000 GBE에 대해서도 마찬가지입니다: 구성 매뉴얼 (18 페이지), 제거 및 교체 절차 (36 페이지), 설치 (21 페이지)

페이지 인쇄

Revised: December, 2008, Release 3.1.7, OL-16595-02

Preparing for Installation

This section contains warnings, tools and part information, and site preparation details.

Warning

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any

equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for

preventing accidents.

Warning

Only trained and qualified personnel should install, replace, or service this equipment.

Warning

Read the installation instructions before you connect the system to its power source.

Warning

This unit is intended for installation in restricted access areas. A restricted access area is where access can only

be gained by service personnel through the use of a special tool, lock and key, or other means of security, and is

controlled by the authority responsible for the location.

Warning

Voltage is present on the backplane when the system is operating. To reduce risk of an electric shock, keep hands

and fingers out of the power supply bays and backplane areas.

Warning

Do not work on the system or connect or disconnect cables during periods of lightning activity.

Warning

Before you begin the installation of the SCE8000, read the

Cisco SCE8000 Platform

Site Preparation

• Verify that the power service at the site is suitable for the SCE8000 chassis.

• Print out and have accessible the

SCE8000 Installation and Configuration Guide

Tools and Parts

Use the following list of tools and parts as a checklist for preparing to install the SCE 8000 chassis:

• Number 1 and number 2 Phillips screwdrivers

• 3/16-inch flat-blade screwdriver

• Tape measure and level

• Masking tape or some other method of marking the desired installation height in the rack

• One grounding lug

• Two M4 (metric) hex-head screws with locking washers

document.

Site Planning Checklist

and the

to record information about this installation.

Regulatory Compliance and Safety Information for the

Cisco SCE8000 Installation Checklist

from the

Cisco