Cisco TelePresenceMCU 5300 Series 시작하기 - 페이지 10
{카테고리_이름} Cisco TelePresenceMCU 5300 Series에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresenceMCU 5300 Series 20 페이지. Multipoint control units
페이지 인쇄
Configuring the MCU
Step one: Log in to the MCU
All administration of the MCU is performed via the web interface.
To log in to the web interface of the MCU:
1
Use your browser to navigate to the IP address or host name of the MCU (to
discover the IP address, refer to the previous section).
2
Click
Log in
information page
Cisco recommends that you change the admin account to use a password
i
as soon as possible. To do that, click
information
required user information.
Step two: Using an H.323 gatekeeper or SIP registrar (optional)
If you have H.323 endpoints, using an H.323 gatekeeper can make it easier for
participants to call in to a conference.
If you have SIP endpoints, using a SIP registrar can make it easier for participants to
call in to a conference.
To configure the MCU to use an H.323 gatekeeper:
1
In the web interface of the MCU, go to
2
Enable
H.323 gatekeeper usage
the online help for further assistance.
3
Click
Apply changes
To configure the MCU to use a SIP registrar:
1
In the web interface, go to
2
Enable
SIP registrar usage
online help for further assistance.
3
Click
Apply changes
Before you configure the MCU to use, and register conferences to, a SIP
i
registrar, you must set up the MCU and its conferences on that SIP
registrar.
and enter the user name
is displayed.
page or go to
.
Settings > SIP
and configure the settings you require, using the
.
with no password. The
admin
Change password
, click the
Users
admin
Settings > H.323
and configure the settings you require, using
.
Configuring the MCU
Login
on the
Login
link, and provide the
.
10