Cisco UCS B420 M3 설치 및 서비스 참고 사항 - 페이지 28

{카테고리_이름} Cisco UCS B420 M3에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B420 M3 38 페이지. High performance blade server
Cisco UCS B420 M3에 대해서도 마찬가지입니다: 업그레이드 매뉴얼 (8 페이지)

페이지 인쇄

Tip

To remove a VIC, reverse the above procedure. You might find it helpful when removing the connector from the

motherboard to gently rock the board along the length of the connector until it loosens.

Figure 20: Installing a VIC mLOM Adapter

Installing an Adapter Card

All the supported mezzanine cards have a common installation process. These cards are updated frequently. Currently supported

cards and the available models for this server are listed in the specification sheets at this URL:

servers-unified-computing/ucs-b-series-blade-servers/datasheet-listing.html

If you are switching from one type of adapter card to another, before you physically perform the switch make sure that you download

the latest device drivers and load them into the server's operating system. For more information, see the firmware management chapter

of one of the Cisco UCS Manager software configuration guides.

Adapter cards can be installed in either slot 1 or slot 2; they can be of the same type or a mixed configuration.

Cisco UCS Manager will recognize adapters in these slots as "Adapter 2" and "Adapter 3," and counts the

Note

mLOM as being "Adapter 1." This does not match the markings on the motherboard.

http://www.cisco.com/c/en/us/products/