Epson Expression 636 설정 매뉴얼 - 페이지 31

{카테고리_이름} Epson Expression 636에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Expression 636 36 페이지. Product support bulletin(s)
Epson Expression 636에 대해서도 마찬가지입니다: 제품 정보 매뉴얼 (5 페이지), 간편한 설정 매뉴얼 (21 페이지), 소프트웨어 설명서 (4 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (14 페이지), 제품 지원 게시판 (5 페이지)

Installing the Network Image Express Card

Install the Network Image Express Card in your scanner by

following the steps below.

1. Turn off the scanner. Unplug any power cords, and then

disconnect all cables from the back panel of your scanner.

2. Remove the two screws using a cross-head screwdriver, and

then remove the plate. Be sure to keep both screws; you may

need to use them again if you re-install the shield plate.

3. Insert the Network Image Express Card in your scanner's

optional interface slot and then tighten the screws.

4. Initialize the Network Image Express Card. To initialize, turn

on the scanner while holding down the Reset button of the

Network Image Express Card for 10 seconds until the red

status light and green data light turn on.

Note:

Be sure to initialize the Network Image Express Card when you

insert or re-insert it in the scanner.

5. Turn off the scanner.

Caution:

Do not install or uninstall the Network Image Express Card

from the scanner while the scanner is turned on; otherwise

damage may occur.

Options