Epson Expression 636 Manual de configuração - Página 31

Procurar online ou descarregar pdf Manual de configuração para Scanner Epson Expression 636. Epson Expression 636 36 páginas. Product support bulletin(s)
Também para Epson Expression 636: Manual de informações do produto (5 páginas), Manual de configuração fácil (21 páginas), Manual do software (4 páginas), Manual (11 páginas), Boletim de apoio ao produto (14 páginas), Boletim de apoio ao produto (5 páginas)

Installing the Network Image Express Card

Install the Network Image Express Card in your scanner by

following the steps below.

1. Turn off the scanner. Unplug any power cords, and then

disconnect all cables from the back panel of your scanner.

2. Remove the two screws using a cross-head screwdriver, and

then remove the plate. Be sure to keep both screws; you may

need to use them again if you re-install the shield plate.

3. Insert the Network Image Express Card in your scanner's

optional interface slot and then tighten the screws.

4. Initialize the Network Image Express Card. To initialize, turn

on the scanner while holding down the Reset button of the

Network Image Express Card for 10 seconds until the red

status light and green data light turn on.

Note:

Be sure to initialize the Network Image Express Card when you

insert or re-insert it in the scanner.

5. Turn off the scanner.

Caution:

Do not install or uninstall the Network Image Express Card

from the scanner while the scanner is turned on; otherwise

damage may occur.

Options