Epson Expression 636 Instrukcja konfiguracji - Strona 31

Przeglądaj online lub pobierz pdf Instrukcja konfiguracji dla Skaner Epson Expression 636. Epson Expression 636 36 stron. Product support bulletin(s)
Również dla Epson Expression 636: Podręcznik z informacjami o produkcie (5 strony), Instrukcja łatwej konfiguracji (21 strony), Instrukcja oprogramowania (4 strony), Podręcznik (11 strony), Biuletyn wsparcia produktu (14 strony), Biuletyn wsparcia produktu (5 strony)

Installing the Network Image Express Card

Install the Network Image Express Card in your scanner by

following the steps below.

1. Turn off the scanner. Unplug any power cords, and then

disconnect all cables from the back panel of your scanner.

2. Remove the two screws using a cross-head screwdriver, and

then remove the plate. Be sure to keep both screws; you may

need to use them again if you re-install the shield plate.

3. Insert the Network Image Express Card in your scanner's

optional interface slot and then tighten the screws.

4. Initialize the Network Image Express Card. To initialize, turn

on the scanner while holding down the Reset button of the

Network Image Express Card for 10 seconds until the red

status light and green data light turn on.

Note:

Be sure to initialize the Network Image Express Card when you

insert or re-insert it in the scanner.

5. Turn off the scanner.

Caution:

Do not install or uninstall the Network Image Express Card

from the scanner while the scanner is turned on; otherwise

damage may occur.

Options