Cisco AT&T 3G MicroCell 시작하기 매뉴얼 - 페이지 5
{카테고리_이름} Cisco AT&T 3G MicroCell에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AT&T 3G MicroCell 11 페이지. Wireless signal booster
Cisco AT&T 3G MicroCell에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 사용자 설명서 (20 페이지), 빠른 시작 매뉴얼 (8 페이지)
페이지 인쇄
Option B
AT&T 3G MicroCell™
Note: If you normally use a USB cable to connect to your modem and computer, refer to 'Connect Your Devices with USB Cables?'
on page 8 of the
Remove the sticker that covers the rear panel of your 3G MicroCell.
To ensure success, it is important to complete the steps below in order.
1.
Disconnect
your current
on the 3G MicroCell.
2. Take the
yellow Ethernet cable
labeled
`Ethernet'
on the 3G MicroCell and the other end to the
3. First,
turn o power
equipment in the following order:
a) Modem
b) 3G MicroCell (
Do this last
the 3G MicroCell and connect the other end to an
High Speed Internet with Modem Attached to Computer
1
2
3
AT&T 3G MicroCell™ User Manual
Ethernet cable from the modem
that came with the 3G MicroCell and connect one end to the yellow
to your current internet equipment.
– connect one end of the
Ethernet Cable
(Included)
Power
Connect AC power adapter
for cabling alternatives.
and reconnect it to the black port labeled
Ethernet port on your modem
Wait 1 minute
, then
AC Power Adapter
AC outlet
.)
This end is attached
to your computer.
Do NOT unplug.
2
last .
.
turn on power
to your Internet
to the port labeled
'Power'
Advance to page 6.
Open Port
Modem
`Computer'
port
on
5