Cisco AT&T 3G MicroCell 시작하기 매뉴얼 - 페이지 4
{카테고리_이름} Cisco AT&T 3G MicroCell에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AT&T 3G MicroCell 11 페이지. Wireless signal booster
Cisco AT&T 3G MicroCell에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 사용자 설명서 (20 페이지), 빠른 시작 매뉴얼 (8 페이지)
페이지 인쇄
Option A
AT&T 3G MicroCell™
Note: Since you have a gateway or Wi-Fi router, you will NOT need to plug anything into the black port labeled 'Computer' on the 3G
Remove the sticker that covers the rear panel of your 3G MicroCell.
To ensure success, it is important to complete the steps below in order.
1. Take the
yellow Ethernet cable
'Ethernet'
on the 3G MicroCell.
2. Connect the other end of the
3. First,
turn o power
in the following order:
a) Gateway or Modem
b) Wi-Fi Router (if you have one)
c) 3G MicroCell (
Do this last
the 3G MicroCell and connect the other end to an
4
High Speed Internet with Gateway or Modem and Wi-Fi Router
Ethernet Cable
1
3
Power
Connect AC power adapter
that came with the 3G MicroCell and connect one end to the yellow
yellow Ethernet cable
to your current internet equipment.
– connect one end of the
(Included)
2
last .
to any open
Ethernet port on your gateway or Wi-Fi router
Wait 1 minute
, then
AC Power Adapter
AC outlet
.)
Gateway or Wi-Fi Router
Open Ports
turn on power
to your Internet equipment
to the port labeled
'Power'
Advance to page 6.
MicroCell.
port labeled
.
on