Cisco ATA 186 개요 - 페이지 4
{카테고리_이름} Cisco ATA 186에 대한 개요을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ATA 186 11 페이지. Analog telephone adaptor
Cisco ATA 186에 대해서도 마찬가지입니다: 구성 (28 페이지), 데이터시트 (7 페이지), 개요 매뉴얼 (11 페이지), 구성 매뉴얼 (8 페이지), 사용자 설명서 (12 페이지), 설치 및 구성 매뉴얼 (13 페이지), 설치 지침 (6 페이지), 구성 (6 페이지)
페이지 인쇄
Hardware Overview
The unit provides the following connectors and indicators:
5V power connector.
•
Two RJ-11 FXS (Foreign Exchange Station) ports—The Cisco ATA supports two independent RJ-11
•
telephone ports that can connect to any standard analog telephone device. Each port supports either
voice calls or fax sessions, and both ports can be used simultaneously.
Note
Ethernet ports
•
–
–
Note
The Cisco ATA 188 RJ-45 LED shows network link and activity. The LED blinks twice when the
•
Cisco ATA is first powered on, then turns off if there is no link or activity. The LED blinks to show
network activity and is solid when there is a link.
The Cisco ATA 186 RJ-45 LED is solid when the Cisco ATA is powered on and blinks to show
•
network activity.
•
Function button—The function button is located on the top panel of the unit (see
Figure 1-6
The function button lights when you pick up the handset of a telephone attached to the Cisco ATA.
The button blinks quickly when the Cisco ATA is upgrading its configuration.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for MGCP (version 3.0)
1-4
The Cisco ATA186-I1 and Cisco ATA188-I1 provide 600-ohm resistive impedance. The Cisco
ATA186-I2 and Cisco ATA188-I2 provide 270 ohm + 750 ohm // 150-nF complex impedance.
The impedance option is requested when you place your order and should match your specific
application. If you are not sure of the applicable configuration, check your country or regional
telephone impedance requirements.
The Cisco ATA 186 has one RJ-45 10BASE-T uplink Ethernet port to connect the
Cisco ATA 186 to a 10/100BASE-T hub or another Ethernet device.
The Cisco ATA 188 has two Ethernet ports: an RJ-45 10/100BASE-T uplink port to connect the
Cisco ATA 188 to a 10/100BASE-T hub or another Ethernet device and an RJ-45
10/100BASE-T data port to connect an Ethernet-capable device, such as a computer, to the
network.
The Cisco ATA 188 performs auto-negotiation for duplexity and speed and is capable of
10/100 Mbps, full-duplex operation. The Cisco ATA 186 is fixed at 10 Mbps, half-duplex
operation.
Function Button
Function
button
A N A L O G
Chapter 1
C I S C O A
T A 1 8 6
T E L E P H
O N E A D
A P T O R
Cisco Analog Telephone Adaptor Overview
Figure
1-6).
OL-4803-01