Cisco TelePresence ISDN GW MSE 8321 시작하기 - 페이지 11
{카테고리_이름} Cisco TelePresence ISDN GW MSE 8321에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence ISDN GW MSE 8321 17 페이지.
Cisco TelePresence ISDN GW MSE 8321에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (15 페이지)
페이지 인쇄
Configuring the ISDN gateway
Step one: Log in to the ISDN gateway
All administration of the ISDN gateway is performed via the web interface.
To log in to the ISDN gateway:
1
Log in to the Supervisor's web interface.
2
Go to
Hardware > Blades
3
Click
Log in
information page
Cisco recommends that you change the admin account to use a password
i
as soon as possible. To do that, click
information
required user information.
Step two: Allocate port licences
Port licenses must be allocated to the ISDN gateway from the Supervisor's
page. Refer to the online help for assistance.
licenses
Step three: Set up the ISDN interfaces
1
In the web interface, go to
2
Select the
ISDN interface type
used in the UK and mainland Europe, T1 (USA and Canada) in North America,
and T1(Japan) in Japan.
3
Complete the other settings as required by your network, referring to the online
help for further information.
4
Click
Apply changes
5
Restart the ISDN gateway (this is only necessary if you changed the ISDN
configuration). To do this:
i
Go to
Settings > Shutdown
ii
Confirm that you want to shut down the ISDN gateway.
iii Click
Restart ISDN GW
6
When the ISDN gateway has restarted, log in to the web interface again, and go
to
Settings > ISDN ports
and click the IP address of the ISDN gateway.
and enter the user name
is displayed.
page or go to
Settings > ISDN
to save any changes you have made to the configuration.
.
.
with no password. The
admin
Change password
, click the
Users
.
to match that of your installation; E1 is typically
, and click
Shut down ISDN GW
Configuring the ISDN gateway
on the
link, and provide the
admin
.
Login
Login
Port
11