Epson FX-880+ 빠른 매뉴얼 - 페이지 19

{카테고리_이름} Epson FX-880+에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson FX-880+ 33 페이지. Epson serial impact dot matrix printers
Epson FX-880+에 대해서도 마찬가지입니다: 설정 매뉴얼 (33 페이지), 브로셔 및 사양 (24 페이지), 매뉴얼 (18 페이지), 사양 (2 페이지), 먼저 읽어보기 (2 페이지), 참조 매뉴얼 (34 페이지)

페이지 인쇄

3. Pull both paper set levers forward until

the paper guides retract and lock open to

allow paper loading.

4. Take a stack of paper (up to 50 sheets)

and fan it. Next, tap the side and bottom

edges of the paper on a flat surface to

even up the stack.

5. Insert the paper stack printable side

down along the left paper guide.

6. Adjust the right paper guide so that it

matches your paper's width. Make sure

the position of the guide allows the

paper to move up and down freely.

7. Push back the paper set levers to clamp

the paper against the guide rollers.

Downloaded from:

http://www.usersmanualguide.com/

EPSON FX-880+/FX-1180+ Quick Guide

8. Attach the stacker-support wires to the

paper guide as shown below, if

necessary.

9. Install the paper guide with the attached

stacker-support by fitting the notches on

the paper guide straight down over the

mounting posts on the printer. Slide the

edge guides to the middle of your paper.

The cut-sheet feeder automatically loads

paper when the printer receives data.

If the first line on your page appears too high

or low, you can adjust its position using the

Micro Adjust function. See "Micro Adjust

Function."

Single Sheets with the Single-Bin Cut-Sheet Feeder (2/2)