Motorola TLKR T7 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Motorola TLKR T7에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola TLKR T7 20 페이지.
Motorola TLKR T7에 대해서도 마찬가지입니다: 소유자 매뉴얼 (28 페이지)

페이지 인쇄

UT035AH EN.fm Page 5 Thursday, June 26, 2008 12:45 PM

Congratulations on your purchase of the TLKR T7 radio.

This product is a lightweight, palm-sized radio. Use it at

sporting events to stay in contact with family and friends,

hiking, skiing, outdoors, or in a neighborhood watch for vital

communication. This compact, state-of-the-art device is

equipped with many features.

Package Contents

Your package contains two TLKR T7 radios, two belt clips,

one charging cradle, AC adapter, two battery support

brackets, two rechargeable NiMH battery packs, and this

reference guide. You may operate the unit 4 AAA alkaline

batteries (not included).

Install the Battery

Your TLKR T7 radio uses the NiMH battery pack or 4 AAA

alkaline batteries (not included). If alkaline batteries are

used, we recommend using high quality alkaline batteries.

To install the NiMH battery pack:

1) Make sure your radio is OFF.

2) Remove the battery compartment door by pressing the

tab at the bottom of the compartment door, allowing the

door to be removed.

3) Install the NiMH batteries into the battery compartment.

Be certain to follow the + and – symbols in the

compartment. Installing the batteries incorrectly will prevent

the unit from operating.

4) Replace the battery compartment door.

Battery Level and Low Battery Alert

This unit has a battery level meter on the display to indicate

the status of the batteries. When the battery in the unit is

low, the battery level meter icon

will flash. Replace the

alkaline batteries immediately.

Charging the Radio

If you use the rechargeable NiMH battery pack, two TLKR

T7 radios can be charged directly or by using the supplied

charging cradle.

Make sure the radio is turned OFF before placing the

radio in the charging cradle. Otherwise the battery level

meter icon will not indicate properly.

Direct Charge

1. Connect the DC adapter's plug to the radio's DC IN 9V

jack and plug the other end to a vehicle's accessory

power outlet.

2. Charge the battery pack for 16 hours.

Using the Charging Cradle

1. Connect the AC adapter to DC IN 9V and to a standard

electrical outlet.

2. Set the charging cradle on the desk or tabletop, and

place the radio in the charging cradle with the keypad

facing forward.

3. Make sure that the LED illuminates. Charge the battery

pack for 16 hours and remove the radio from the charg-

ing cradle after charge.

The charge indicator LEDs will remain on as long

Note:

as the radios are left in the charger.