Epson Stylus Pro 4880 Portrait Edition 설정 매뉴얼 - 페이지 12

{카테고리_이름} Epson Stylus Pro 4880 Portrait Edition에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Pro 4880 Portrait Edition 16 페이지. Warranty statement
Epson Stylus Pro 4880 Portrait Edition에 대해서도 마찬가지입니다: 브로셔 (1 페이지), 사양 시트 (6 페이지), 브로셔 및 사양 (6 페이지), 빠른 참조 매뉴얼 (12 페이지), 네트워크 매뉴얼 (46 페이지), 설치 매뉴얼 (4 페이지), 제품 정보 매뉴얼 (16 페이지), 제한 보증 (12 페이지)

페이지 인쇄
Epson Stylus Pro 4880 Portrait Edition 설정 매뉴얼
8. Adjust the length of the paper guide and the
edge guide according to the paper size.
9. Put the paper guide roller down, and then
re-attach the paper tray cover.
Note:
Make sure the roll paper support is not raised.
10
Loading paper into the rear manual
feed slot
Note:
❏ You can load one sheet at a time into the rear feed
slot.
❏ Load paper with the printable surface up.
❏ Paper with a thickness between 0.08 and 1.6 mm
can be set in the landscape position. However,
always set recycled or plain paper and A4, Letter
size, or 8 × 10 in. paper in the portrait position,
regardless of the thickness.
1. Make sure the printer is on and in the READY
state.
2. Press the Paper Source
Sheet
on the LCD panel.
3. Hold the left and right edges of the paper.
Align the left edge of the paper with the target
paper size on the roll paper cover, and then
insert the paper until it meets resistance.
The printer automatically feeds the paper to
the printing position.
Note:
If you press the Pause button, the printer starts to
feed the paper to the printing position immediately.
button to select