Epson Stylus Pro 4880 Portrait Edition 빠른 참조 매뉴얼 - 페이지 3

{카테고리_이름} Epson Stylus Pro 4880 Portrait Edition에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Pro 4880 Portrait Edition 12 페이지. Warranty statement
Epson Stylus Pro 4880 Portrait Edition에 대해서도 마찬가지입니다: 브로셔 (1 페이지), 사양 시트 (6 페이지), 브로셔 및 사양 (6 페이지), 설정 매뉴얼 (16 페이지), 네트워크 매뉴얼 (46 페이지), 설치 매뉴얼 (4 페이지), 제품 정보 매뉴얼 (16 페이지), 제한 보증 (12 페이지)

Epson Stylus Pro 4880 Portrait Edition 빠른 참조 매뉴얼

Loading Paper in the Tray

Loading Paper in the Tray
Make sure the printer is on and roll paper is not loaded
for printing.
1
If your paper size is A3 or larger, pull out the paper
tray and cover.
2
Lift up the paper tray cover.
3
Flip up the paper guide roller and slide the edge
guide all the way to the left.
4
Thumb through a stack of paper, then gently tap it
on a flat surface to even the pages.
5
Load the sheets in the portrait orientation, short
edge first, with the printable side face-down. Place
the paper all the way back, against the right side of
the tray.
Don't load paper above the arrow mark inside the
edge guide.
Caution:
When you add more paper, always line up
the edges with the paper already in the tray.
6
Adjust the paper tray and edge guide according to
the paper size. For sheets smaller than A3, raise the
paper guide and move it to the edge of the stack.
7
Flip down the paper guide roller, adjust the length
of the paper tray cover (if necessary), then replace
the paper tray cover.
Note:
Make sure the roll paper support is
not raised.
8
Press the paper source button until you see the
cut sheet icon.
2